How to Clean the Trumpet

This article was originally published by Ken Saul of Ultra Pure Oils, it is clear and comprehensive so I have re-published it here! Other brands are of course available to use, but I am yet to find any cleaning and maintenance accessories that are as slick and reliable as Ultra Pure.

Keep your horn clean and you will never have a problem with sticky valves or slides. Keeping it clean inside also removes bacteria that can build up in the tubing.

VISIT THE ‘EDUCATIONAL RESOURCES’ PAGE FOR FREE WORKSHEETS AND LINKS TO PUBLICATIONS

Daily Wipe Down

You should wipe off your trumpet at the end of each day using the Ultra-Pure microfiber polishing cloth. Gently wipe all the surfaces, especially where you hold the horn. Wipe off any water spots. The microfiber cloth will soak up oils and grease and should be washed once a month. If you have a silver plated trumpet, you can use a silver polishing cloth to remove tarnish about once a week. Use it to wipe the outside of the instrument only.

microfiber cloth and trumpet cleaning
Wipe the outside of the horn every day to remove fingerprints, water spots and oils.

Bath Time

You should give your trumpet a bath about every month or two to keep it in the best condition. It only takes about 30 minutes to do a good job.

Carefully pull out the main tuning slide and the three valve slides. Wipe off any grease on slides with a paper towel. Remove the bottom valve caps. If they are stuck, try using a rubber jar opener, not pliers. Also wipe off the bottom valve caps with the paper towel. Then remove the three valves. They are numbered 1, 2, and 3. When you pull out the valves, check which way the number faces, the mouthpiece or bell end. When you put the valves back, they will face the same way.

Put a rubber mat or a towel in a tub or large sink and fill it with lukewarm water. Add some lemon-scented dishwashing liquid detergent (about a tablespoon is enough). Gently immerse the trumpet, the slides, the bottom valve caps, and your mouthpiece. Put some of the soapy water in a glass and immerse the valves, keeping the felts dry. Let everything soak for 10 minutes or more.

soaking a trumpet for cleaning
Take the trumpet apart and soak it in lukewarm (not hot) soapy water.
Trumpet valves soaking in a glass of soapy water
Soak the valves in soapy water while keeping the felts dry.

Run the snake through the leadpipe and all the trumpet body tubing several times. Run it down the bell and around the back bend. Use the snake to clean the insides of the tuning slide and the valve slides. Don’t force the snake if it does not bend around the tubing easily.

Cleaning a trumpet with a snake brush
Use the flexible snake brush to clean all the inner tubing.

Scrub the valve casings from the top and from the bottom with the valve casing brush. Clean the bottom valve caps carefully to remove all the residues. Finally, clean the mouthpiece with the mouthpiece brush. Drain the tub or sink and rinse all the parts completely. Let them dry on a towel.

scrubbing a trumpet valve casing
Scrub the valve casings with the cylindrical brush.
Cleaning a trumpet mouthpiece
Scrub the mouthpiece with the tapered brush.

Clean the valves

Gently clean the valve ports with soapy water using the snake brush or the valve casing brush. Scrub the valve surface with soapy water using the valve casing brush or an old toothbrush. Be careful not to scratch the valve surface. Wash the valves with plenty of clean water and let them dry on a towel.

Lubricate the slides

Put a small amount of Ultra-Pure Regular Tuning Slide Lube on your finger and rub it onto the slide. Insert the slide all the way and wipe off any excess lube with a paper towel. If you are used to moving the first and third valve slides quickly for more accurate tuning, you should use Ultra-Pure Light Tuning Slide Lube on these slides. Also, rub a little slide lube on the top and bottom valve casing threads. Slides should be lubed about once a week or two.

Grease a trumpet tuning slide
Rub a small amount of tuning slide grease on each slide and put it back into the horn. Wipe off any excess grease with a paper towel.

Oil the valves

Hold the valve over a sink, cloth or newspaper and coat it with plenty of Ultra-Pure Professional Valve Oil.  Carefully put it back into the casing and make sure the valve “clicks” into place, facing the right direction. When putting the valve back in its casing, do not rotate it since this can cause excessive wear. Screw the bottom valve caps back on. After the valves are in, try blowing some air into the leadpipe while moving the pistons. If air stops, you probably have one or more valves in backward.

Valve oil and a trumpet valve
Drip plenty of valve oil onto the valve surface to lubricate it.

Reapply valve oil every day or two

You should oil your valves every day or two. Just unscrew the valve and pull it up and out of the casing. Coat the valve with oil and carefully put it back in the casing. 

Treat your instrument gently

Be gentle with your instrument. It is dented easily and dents make the instrument harder to play or can cause valves or slides to stick. Keep the horn in your hands, on your lap, or in the case. Not on the bed, a chair, or on the floor. If the instrument gets a dent, or if your mouthpiece gets stuck, take it to a music store to be repaired professionally.

VISIT THE ‘EDUCATIONAL RESOURCES’ PAGE FOR FREE WORKSHEETS AND LINKS TO PUBLICATIONS

You may also be interested to read this article about ‘Bagpipe Lung’ to emphasise the importance of keeping your trumpet clean!


Sign up here for new blog articles emailed direct to your inbox:


Claude Gordon Practice Routines

The following article was originally written by Jeff Purtle and published in The Brass herald in 2009. Jeff Purtle is a private teacher, clinician, and trumpet player with international clientele. As a protégé of Claude Gordon he continues the traditions of Claude Gordon and Herbert L. Clarke with effortless playing and productive practice. Please visit purtle.com for a fabulous range of educational content.


A practice routine is a tool to become an excellent and consistent player. It also gives a scientific way to understand how to improve specific skills. These qualities are essential for a long successful career. Claude Gordon believed anyone could be a “virtuoso” if he knew how to practice.

Gordon took Herbert L. Clarke’s principles and applied them with more structure. My previous article defined the content and this article is about the practical application. The assignments serve to set goals and understand what causes the progress. Refer to the pictured assignment from Gordon and the explanation below. Even Gordon improved his teaching over the years by using this method.

Claude Gordon Practice Routine - Jeff Purtle - Jan 28, 1985

VISIT THE ‘EDUCATIONAL RESOURCES’ PAGE FOR FREE WORKSHEETS AND LINKS TO PUBLICATIONS

Breathing Exercises

Breathing Exercises are always the first item. The focus is on taking a “Big Breath” and maintaining the chest in an “up” position during both inhale and exhale. Forget about the stomach or diaphragm. If the chest stays up you cannot breath incorrectly. The first exercise is 5 sets of 10 breaths standing in place. The second exercise is called “5 Walking,” which is 5 equal sniffs-inhaling while walking, 5 holding-full, 5 puffs-exhaling, and 5 holding-empty, then repeating this cycle walking a square city block. Each month it progresses one more step, then after 10 walking it moves to 5 jogging until finally reaching 10 jogging. Another form of breathing exercise is the “long hold” in the “Range Study” section.

Order

Sections A through D of the CG assignment were usually flexibility studies, intervals, tonguing and scales. Tongue Level studies should usually be the first thing to play. Gordon said, “The air does the work; the tongue channels the pitch.” They develop flexibility and ease in navigating the instrument. It is similar to stretching before a physical sport to be flexible. Gordon’s Daily Trumpet Routines book is excellent to use with all the models. Other flexibility books like ColinIronsWalter Smith and Staigers may be used in this area too. The point is to “watch the tongue” and learn how to coordinate the wind power and tongue level to discover how to “let the air do the work”, as Gordon said, and not be focused on the lip. Collect all possible material in this category even from other instruments as Gordon did.

Section I of the CG assignment is where the fingers and breath control are developed while working on Clarke’s Technical Studies. The first priority is to “strike the valves hard and lift the fingers high”, which is mandatory. Do each study with seven days of each of the following: single tongued, K tongued, double (or triple) tongued, and finally slurring as written. Practice accurately to play accurately. Things should then be prioritized as follows: accuracy, evenness, speed, whisper soft playing and finally repetitions in one breath. Never play softer than you can get a secure sound. Other scales and arpeggio studies fit in this area too, but Clarke’s book should be reviewed at least annually. Refer to Gordon’s Systematic Approach book for the some of the fingerings from Clarke that were passed down to Gordon. These are mandatory to train the fingers to function independently of each other with speed and control.

How You Practice

“How You Practice” was Gordon’s label for a way of practicing technical etudes and problem passages. It involves starting on the last beat of the music and progressively working backward one beat at a time with four perfect performances in a row before moving to the next step. (Use diagram with steps.)

How You Practice Diagram

Range Study

Down Routine

Claude Gordon - Systematic Approach - Down Routine

Section II of the CG assignment is the Range Study area. This takes the player first into the pedal tones (i.e. “Down Routine”), followed by a 5-10 minute rest, then to the high register (i.e. “Up Routine”), followed by a brief warm down (i.e. “Relax Lip”) and an hour long rest.  All the other routine elements work along with the Range Study to increase the player’s range. The goal is a more playable range, usable in all situations. 

Up Routine

Claude Gordon - Systematic Approach - Up Routine

The “long hold” in the Down Routine is held until the sound stops and all the air is expelled. This is an isometric type of exercise that strengthens the muscles used for blowing. You never do a hold like that on high notes. The Down Routine played before the Up Routine helps the player discover how to play high with ease as opposed to tightness. Playing from pedals to the high register can be effortless if worked on systematically. The rests are not literally four beats, but you must rest as much as you play with the mouthpiece off the lips to avoid fatigue and bad habits that come from playing when tired. Gordon said, “If you rest properly you can play all day.” This also develops endurance by learning the knack of playing with ease instead of by brute force. “Watch the tongue” meant to visualize the tongue and feel it’s unique vowel position for every note. This is how you learn to play accurately. The “Eee” syllable must be in the very front of the tongue for faster air speed. Gordon said, “Let the air do the work and let the air save the lip.” This means to blow stronger when ascending to get the right feel. Pedal F through C# should be played in tune. Pedal C through Pedal F# are initially very flat for most people, but the pitch will come up in time. It is possible to play to the third pedal C or lower. The pedals help improve a free vibration of the lips and indirectly help many aspects of playing. Care must be taken to not play them too loud.

Start the Up Routine in the pedals. On the first arpeggio leave pedal C below pitch, but play pedal E in tune by sounding the note 8va to get a reference pitch before playing the arpeggio. This fermata should only be a brief hold with a crescendo. Rest between each key. Continue up as far as possible. Remember this is a calisthenic exercise more than a musical exercise. Work up as high as possible, making only make three attempts at the highest note and then stopping to avoid developing bad habits.

Relax Lip

Relax Lip Warm Down to Pedal C and Lower

“Relax Lip” was a brief warm down to be played 3x after the Range Study. It can also be played other times. After the Range Study and “Relax Lip” the player shouldn’t play a note for an hour in order to completely recover. It is also wise to not do the Range Study before a demanding performance.

Technique Applied

Section III of the CG assignment is where solos, etudes, orchestral excerpts and other music is placed. The Range Study can also be placed at the very end of the routine with the etudes before it.

There are other variations that can be made to the routine, but this is the normal way. See the article What To Practice on www.purtle.com for a list of books to use in the routines. The practice routines are how the player can learn that brass playing is no harder than deep breathing. It’s not luck or natural talent. After playing the routine you should feel better than when you started. The goal of the routine is to learn to play with ease.

There is a balance between staying too long on an exercise and loosing focus vs. not staying long enough for the exercise to accomplish the desired result. Sometimes the same items can be worked on with variations. A teacher can spot things we ourselves don’t notice.

Personal Use

Claude Gordon Certified Teacher Certificate

In order to teach correctly you have to play correctly and understand it. Gordon said the following on my pedagogy certificate from 1989, “…with personal use of these principles is hereby qualified to teach correctly.” Gordon knew that the teacher must be in tune with his own playing and practice in order to take students along the road to improvement.